This powerful three-phase equipment, based on the latest evolution of the consolidated Thyristor technology, grants reliability and safety in any work condition. The innovating cutting current control system Total Wave Control TWC and the electronic adjustment allow to select the very best parameters in any application, granting superior cutting quality on any thickness and material . Plasma Plus 150 E enables the utilisation of different amperage torches, air or water cooled, by also automatically recognizing the used torch and changing the range of cutting currents for each fitted torch. The control panel helps the operator by automatically indicating the correct tip diameter to be used depending on both used torch and preselected cutting current.

Digital panel for preselection and reading of the cutting current

Continuous cutting current adjustment

Possibility of using different amperage torches

Identification of the used torch and automatic cutting current range change from 25A - 75A to 25A
- 150A

Cutting parameters stability within ± 10% mains voltage fluctuations

Filter and regulator group with air impurity automatic expulsion

Contact cutting possibility with currents below 50A without sliding blocks or other spacers

Possibility of use on an automatic cutting equipment

Automatic fan motor switching off 9 minutes after cutting operation is over, to reduce airborne
contaminants drawn into the equipment